Some Announcements on Polishing and Grinding of Polishing Materials

The final purpose of polishing and grinding of polishing materials is to find a way to improve the polishing rate. At the same time, the polishing damaged layer influences the final observed group. The former requires relatively coarse abrasive polishing materials, while the latter requires the finest polishing materials. To solve the problem of these two abrasive polishing materials at the same time, what we need to do?

If you use sanding paper for polishing and grinding, you should put the grinding surface of samples and polishing grinding disc on a parallel position. At the same time, you should also make the sample rotating and moving along the radius direction of grinding rotating disc to and fro, in order to avoid local wear too fast, and in the process of polishing, you should keep adding abrasive powder slurry, and make abrasive polishing materials fabric keep certain humidity.

What announcements on polishing and grinding of polishing materials? Firstly, the speed of polishing grinding disc had better not exceed the speed of 500 r/min. Because the time of polishing and grinding should be long and the speed can be appropriately increased when fine polishing. Therefore, the polishing time should be the time that the coarse grinding damage layer is thrown off, which can help provide the accurate market intelligence information and scientific decision basis for strategic investor to choose the appropriate investment timing and company leaders to do strategic planning.